Guide Shaft for Pull Arm in Polar 115 CE Paper Cutters

Guide shaft or guide rod for the center of the pull arm on Polar 115CE paper cutters (218649, 221717). This 14mm diameter alignment rod fits up the middle of the pull arm on the Polar 115 CE cutters to prevent it from flapping around and causing damage when the shear bolts break. It is made from centerless ground drill rod for maximum toughness. Its overall length is approximately 15″ long.

It is used in pull arms which have a set screw for locking the bottom of the guide rod in place in the pull arm. If your pull arm uses a roll pin to lock the bottom of the guide rod in place then you need our part number GS-351.